|
|
#11
01-31-2016, 03:58 PM
|
||||
|
||||
Re: Great Dane excavating co.
 Got the rough length of cylinders. The shaft is short in pic, keeping everything long till I can get the swivel bearing on cylinder finalized. And to figure out how/where to have oil inlet/exit ports. They are going to be the hard part. Hats off to you guys working on small stuff!! 1/4" id cutting internal grooves for the orings is about my limit  . And I know for some of you that may be big stuff!!!
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
| Currently Active Users Viewing This Thread: 4 (0 members and 4 guests) | |
|
|
Threaded Mode