|
|
#11
02-04-2016, 07:35 PM
|
||||
|
||||
Re: Great Dane excavating co.
 I know I said I wasn't going to make hardliners for the steering cylinders,,,,, but,,,, I did! Couple of distractions leading to soldering wrong lines in wrong places. And thought I was off on oil ports as air was escaping inside cylinder. Found out it was bypassing through the screw threads holding piston to shaft. A little bit of Teflon to seal and no leaks. On final assembly I'll use thread lock and let dry.
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
| Currently Active Users Viewing This Thread: 41 (0 members and 41 guests) | |
|
|
Threaded Mode