![]() |
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#6
|
||||
|
||||
|
If the screw was loose and wore the shaft out of round - you might be able to have it machined true again and then have the mating parts sleeved so that the run concentric again. As travis said above - PFB had a the plastic ring that couples the motor to the pump split. a new sleeve is required to fix.
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|