|
|
|||||||
| Truck Building Tech Covers mechanical and electrical components for truck modeling |
|
|
Thread Tools | Display Modes |
|
#2
05-16-2013, 01:00 AM
|
|||
|
|||
Re: Worm gear for trailer ramps
It'd work on the Carson Goldhofer STN-3L as well...
I see in the desc he's using a 1:10 winch, probably the stock RC4WD one, but how to connect that to the screw-drive-shaft, and then where to find the steel worm-gearing for the shaft-to-axle-hingepin... Bet a lot of others would likee the 'hint' too... all the vids I've seen show the ramps being operated from topside... or a still of the underside w/o close-up or showing it in operation. Anyone? WhiteWolf 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode