|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#32
12-03-2010, 10:06 PM
|
||||
|
||||
Re: broken bits
I put my 3mm tap in a 7.2v reversable cordless drill, keep the tapp well lubed and clean the tap constantly with a brass brush. Barely pulling the trigger, when it stalls, back it out, clean/relube the tapp, blow out the hole with pressurized air and go again. Haven't broke a tap yet, wore a few of them though.
That tap guide you show Jeff looks to be the cats meow, very simple & effective. 
Last edited by Lil Giants; 12-03-2010 at 10:09 PM. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode