|
|
|||||||
| Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
|
|
Thread Tools | Display Modes |
|
#5
12-07-2010, 09:51 PM
|
|||
|
|||
Re: Another machining question
On the jump style finders, you still have to watch when it goes off center-correct. The laser type depends on seeing the light at the edge or center point. I think the only one that would help me is this one-
http://www.victornet.com/alphabetic/...ders/1606.html The model GAE-EF is the one I was looking at . Anyone familiar with this? 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode