holms 450

[Nikaem]

moving on
parts for the pulley system on one boom

the pieces make these

the boom pieces



I was going to use these wheels ant tires now new idea

just need parts of the rim had to do 4 rims tor this truck

had to remove the outer ring and trim off the lip

[Nikaem]

so then had to cut the center out of this rim

test fit the two pieces there is a big gap need to do something

cut a bunch of scrap lamicoid

stack up 4 pieces


attach the stacks to the rim

test fit all good attach the inner to the outer rim

______________________________________
repeat for the other three rims
now back to the deck here is the back stop that all the booms attach to

the sling


the winches

the boom swivel pivot thing

----------------------------------
the pulley end of the boom

[Nikaem]

tossed the frame and built a new on also went to leafs in the rear