Clean & Mean Grand Hauler Build

[janderson]

Originally Posted by tippa

hi ...wondering if you can help I am building a grand following your clean and mean step by step (great help): but now I come to mounting the mfu I find the servo wires are to short and if I move the mfu forward then the tail light wires are too short ... any help much appreciated ...regards ..geoff

Hello Geoff,

Well as we know the MFU harness is a set length. I used no extensions, so the only thing I can say for help would be.

#1 Make sure you route the the rear tail lights as straight as possible and on the frame side that gives to the best straight route.

#2 There is a possibility that servo wire length could be different, you could use an extension on your servo wires.

#3 The way I built the truck there was not much wiggle room.



It is hard for me to give you an exact cause when I do not have it in front of me or any pictures of your build and routing.

Hope this helps.

(This was sent in via a private message)