|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#8
12-23-2010, 11:03 PM
|
||||
|
||||
Re: Duty cycle on servos??
Some servos do not have 360 deg final gears as well. A HiTEC HS-85MG only has half of a gear for the out put I found that out after I cut the mounting tabs off to fit it in my Service Truck Boom and when I opened it and seen half of a gear I was upset with myself for not checking that first but that is a mistake I won't make again.
Travis
__________________
AKA "00" Biddle RIP FreddyGearDrive 2-12-59/12-19-11 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode