|
|
|||||||
| General Discussion A place to post off topic discussions. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
12-28-2010, 09:21 AM
|
||||
|
||||
Re: GD-600 for Gear Reduction for King Hauler
You can also just put .125" spacer between the servos and their mounting. In other words, lower the servos by .125". No need for modifying the floor plate that way.
Lynn 
|
|
#2
12-28-2010, 09:40 AM
|
|||
|
|||
|
Re: GD-600 for Gear Reduction for King Hauler
Here's a close up of a GD600 that's in my Masolite Block Truck. The servo's are lowered as Lynn described and I also added one washer under the front transmission mounting tabs on each side. Works great, no clearance problems.
Dennis 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
