CAT 14M3 Motor Grader

[Hemi1966]

Hi guys, it's been a while since last update.
I've been drawing the cab and the engine enclosure, and those parts I was thinking to 3D print. You who have used 3D printer for parts like those, how would you print them ? Do you print it wall by wall flat the build plate, or how would you do it ?

I got some machining done also. This is the rear sub frame for the ripper

I was trying to upload these pictures from Photobucket, but no matter what I did they showed up on the original size I give up, switching to Postimages.