RC Truck and Construction  

Go Back   RC Truck and Construction > RC Tech section. > Truck Building Tech
Reload this Page Screw Lift & Dump Bed?
Register FAQ Calendar Search Today's Posts Mark Forums Read

Truck Building Tech Covers mechanical and electrical components for truck modeling


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #6  
Old 03-22-2012, 03:38 PM
fhhhstix's Avatar
fhhhstix fhhhstix is offline
Out of control
  
Join Date: Aug 2010
Location: Kirklin IN.
Posts: 3,788
fhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud of
Default Re: Screw Lift & Dump Bed?
Matt it is just a lock nut that pushes on a thrust bearing to allow the rod to spin freely as the rod pushes against the rear block. I drill through the rear block and use the lock nut against the thrust bearing to set the preload of the rod so as the dump goes up and pushes on the rear block it does not allow the rod to pull on the gear motor.



Travis
__________________
AKA "00" Biddle


RIP FreddyGearDrive 2-12-59/12-19-11
Reply With Quote
 

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 04:36 PM.

Contact Us - RC Truck and Construction - Archive - Top

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.