|
|
|||||||
| Australian Rigs & Roadtrains A place for aussies to show off their unique truck configurations. |
|
|
Thread Tools | Display Modes |
|
#11
08-14-2012, 06:26 AM
|
|||
|
|||
Re: Scania W.A. Prime Mover 1/14.5
After little Break, the construction goes on
 First a few pics from Events    I made a little bit on the Trailers. The rear bumber for the Dolly and the Lead was milled by a 8mm Alu-platte.    For the 45" Trailer, i made alu-plates on the exist brass-bumber. the holes are for the LED because of the small mounting deep of the original rearlights.   I went for the rail construction aluminum holder.    Next, I have 106 brass holder soft solder 
Last edited by Marcel74; 08-14-2012 at 11:09 AM. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode