Utility Truck

[cyanide]

To finish mounting the bonnet I needed to put in the barwork on the grill, which is drilled out of the hoop and dropped down and plug welded in. Once that was done I could knock back the flat bar on the top of the hoop. I got that done on Saturday.





I used incorrrect hinges, so I am going to redo the bonnet with hinges I pulled out of an old rack mount server, but, they are stashed in a storage box, so I'll have to wait untill the contractors are finished at our house. I'll proberlly add more mesh, not sure if it will be infront, or behind the bars yet.