twins

[ihbuilder]

Az , Nate thank you

Dan, thank you , 1 setup as of now all done by 3D milling . I'm going to have to set it on the 2* taper from top to bottom to clean up the logo . A sin plate would be nice right now But , I'll make do . The bottom part I'll do a couple setups cause it's only 1" thick . I was going to flat surface all the angles with jigs . The 3D work actually ran pretty quick at 120 IPM with .5" ball mill . finish came out good for paint . The logo area took the longest , that I learned would be better on another setup