what do you need to run leimbach hydraulics?

[Lil Giants]

To set the pressure? Sure Rob, very simple procedure. When you get your pump you'll see a black button head bolt on the side of the pump, remove that & the pressure screw is inside there. The torx screw is pushing on a spring forcing a steel ball into the return port restricting the oil flow back to the reservior. You don't have to turn it much to increase the pressure. The pump has to be OFF while adjusting the torx screw, install button head bolt before turning ON pump again.

If you're getting the pressure guage, screw the barbed fitting into the 2nd hole on the side of the filter can.

[carp]

thanks for all the replies guys, it was going to be for an excavator 1:14 zaxis 870 similar to the vario one but homebuilt, at least now i know how much its going to cost me roughly, at 15bar pressure what sort of weight can you lift?