Manufacture Hydraulic Pump?

[ihbuilder]

OK , now I know the slang for it , sickle gear is nothing more then a vain . most furnace pumps are vain pumps as far as I know . I got my seal for mine ,just did not get it installed yet . I've been busy with wheel orders and a job that finally came up . I have no doubt about flow rate , just skeptical on pressure . My dad has suggested a furnace pump also ,I just did not get there yet . I have a couple

IHSteve

[ihbuilder]

Originally Posted by ihbuilder

OK , now I know the slang for it , sickle gear is nothing more then a vain . most furnace pumps are vain pumps as far as I know . I got my seal for mine ,just did not get it installed yet . I've been busy with wheel orders and a job that finally came up . I have no doubt about flow rate , just skeptical on pressure . My dad has suggested a furnace pump also ,I just did not get there yet . I have a couple

IHSteve

I stand corrected , a sickle gear set is just what the jung pump has . I finally got to take a furnace pump apart and ohlala just what I've been looking for and the right size to . now to make the right size housing for it ,HMMMMMM come to think of it , I think the newer furnace pumps are about the right size . oh more research

Originally Posted by Bellien

If you are still considering building a pump, have you considered using the sickle gear set out of a furnace oil pump?

thank you so much for bringing this up made me check it out sooner then later

IHSteve

[trucker n]

what is a furnace pump

[ihbuilder]

Originally Posted by trucker n

what is a furnace pump

oil furnace to heat your house , unless you live where it's a constant 90 deg all year round .

[trucker n]

i have heat but dont use it much and it is gas so no pump where can i get one

[22fatcat]

Hi, I have built two pumps, the first one was very loud and it moved to much oil not very efficient. the second one i used a much smaller gear and it seems to work pretty good but it has not been used on my excavator yet I just recently bought the spool valve from Rc4wd and need to finish the connections and make an overflow tank. Hopefully this one will work well.