View Single Post
  #3  
Old 07-04-2011, 01:55 PM
ihbuilder's Avatar
ihbuilder ihbuilder is offline
Fabrication and design , super moderator
 
Join Date: Aug 2010
Location: in a cage in Auburn,PA
Posts: 3,557
ihbuilder is a jewel in the roughihbuilder is a jewel in the roughihbuilder is a jewel in the roughihbuilder is a jewel in the rough
Default Re: reinke 48'x102 drop deck

Quote:
Originally Posted by Car5858 View Post
I will be following this build

As for the jumping on the X axis, what are your steps set to, and what operating system is the mill using?
soon to get hit with a BFH pre dates PC Centurion IV by milltronics no longer supported there's more then that wrong with it . I think this POS is getting yanked out by next weekend hopefully when the newer 1 comes and just figure how to do it with the smaller table this deffinately needs a new control any one need a boat anchor !! Cheap!!!!!
__________________
RIP FreddyGearDrive 2-12-59/12-19-11

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Reply With Quote