|
|
|||||||
| Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
|
|
Thread Tools | Display Modes |
|
#6
03-08-2011, 04:49 PM
|
||||
|
||||
Re: Is this a good machine for the $$$
Not a bad starter mill. Only thing that is wierd is the .062" per revolution on the X and Y handles. Looks about like the one that quite a few of us have only different color paint. Wish mine had the R8 spindle and not an M3. I have never been satisfied with mine but I think it is my fault and not the machine. Just need to take the time to completely take the table off and clean everything.
Lynn 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode