Drilling custom frame - RC Truck and Construction

		RC Truck and Construction > RC Tech section. > Truck Building Tech
Drilling custom frame

Truck Building Tech Covers mechanical and electrical components for truck modeling

Thread Tools

Display Modes

05-24-2014, 05:27 PM

cabs

Apprentice

Join Date: Sep 2013

Location: Alpha NJ

Posts: 395

Re: Drilling custom frame

I always mark center punch and them drill with press so I can keep the hole lined up correctly to the inside.sometimes its tough. If you mess up just make it a little bigger and nut and bolt it. Good luck

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 12:15 PM.