3D Printed D10T Build

[JDH429]

Originally Posted by TRUCKMAKER

Thanks Jason, that's not bad as far as a kit would go, design and print, well thats a different story!

Yes, if i had a larger printer some parts would not need to be cut up, so would mean less parts, but the same amount of time. There are few things i would change in the design if i made another one. It was fairly time consuming for this one build...

A few more pics and vid of the full assembled running test with sound. Imagine you dont hear the air purge And excuse the slight shakiness of the video, I had clamped my phone to a 60" straight edge, and it wombled a bit as it was leaning against the table. I also need a little practice smoothing out my control.














Bench Test vid

https://www.youtube.com/watch?v=fMtr...ature=youtu.be