left over build (Cat 825C maybe )

[ihbuilder]

Oh boy now I'm stoked did a lil wiring and morpower valve mods between part changes . now she rolls

vid is narrow view

http://youtu.be/Zyf_6gxWp8w

pic of it gettin tight under the hood and a few next to the 990 .







thanks for lookin

[RCP57]

Sweet! Have you ran any juice through the morpower stuff yet? Are you running their pump in this too? I keep looking at their stuff but have been reluctant to pull the trigger on it. I want it for something that won't run a bunch of pressure but you know how that goes....

Keep the progress goin!

[ihbuilder]

Reg , I just bought the valves from them for this awhile back . The pump is a Micropump I got off ebay ( thread in the construction teck forum ) I modified it for the $* log truck but it was just to bulky to look right with the limited room I have on that truck . So it went here . I have to make cylinders and a PRV and need an esc for the pump and finish the blade then it'll be full operational . The quickest and relaxing build yet for me that didn't cost a bunch like my big Mack

[ihbuilder]

All I got done this weekend . ran over on a production run that needed to be done .

Axle pivot pins





Back floor pan for elec's

[ihbuilder]

1st we started with 4"x5" bar (what was laying around that would work )



end result , top portion of ROP






thanks for lookin