1/16 Oliver Dozer Conversion - RC Truck and Construction

		RC Truck and Construction > RC Truck's Odds and Ends. > Die-Cast Conversions Tech.
1/16 Oliver Dozer Conversion

Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models.

Thread Tools

Display Modes

08-22-2014, 11:48 AM

Rvjimd

Craftsman

Join Date: Dec 2012

Location: Des Moines, Iowa

Posts: 884

Re: 1/16 Oliver Dozer Conversion

Here are two pictures of the current frame mod to accept the hitec 225MG servos. The angle parts are attached to the casting on the sides and the small brackets capture the servos. Working on a new set of brackets to go up to the 645MG servos. At this point the frame width is too narrow, not sure how I'm going to get the full sized servos in there?

Jim

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 05:31 AM.