JBC limited NZ

[andyathome]

Have just finnished installing the new track drive motors.
Found out why the tracks were jumping, I have sheared both pins; probaly due to driving small gravel and ignoring the bad sounds .
I didnt have 2mm by 35mm pins lying around .
measured a few pop rivets and they are a perfect fit.
1 battery flat , new motors work sweet and the pins are still going strong.

[andyathome]

ok, finally bit the bullet and got another lowboy for the fleet.
was a stock standard rc4wd lowboy but it needed some upgrades.
all the fleet trailers are red so ,out with the spray can.
also cut up some 5mm MDF sheet and used a slitter blade in the grinder to make some fake planks.