360 servo creeping

[cosworth34677]

Originally Posted by sleepiejay

So I have converted my first servo ( hitec 325hb) to 360 rotation by taking out the pot and replaced it with 2 resistors of the value. It works well but a little hard to center or stop, I can deal with that. The problem is when I turn it off and then back on to use it again it starts turning slowly. I can us the trim to stop it but just wondered if I missed somthing ?

what i did was just take the esc out of the servo and used a small 1/18 scale esc. the reason was the creep on my track loader was so bad it was almost un-driveable but also i've found that some companys servo are better then other at 360 converts futaba's work better the hitec and both work better the traxxas and china brands

[sleepiejay]

Thanks for the help and it all makes sence. I will leave it as is and see how it goes and if it don't like it I think I will go with the esc.