Mack DM800 Dump

[RCP57]

Hope you don't mind me posting these here Keith. Does this look like it will work? I know it's the wrong Mack, but at least it's a Mack...

[Kaf343]

Originally Posted by RCP57

Hope you don't mind me posting these here Keith. Does this look like it will work? I know it's the wrong Mack, but at least it's a Mack...

Once again Reg, you nailed it. I've already started on the frame and lift mech so once I get the plow blade I'll be in business. Nice job! Can't wait.

[RCP57]

Awesome Keith. Are you thinking of putting a softer cutting edge on it? I was looking around at stuff I had but wasn't sure if I should stick anything on there for you?

[Kaf343]

Originally Posted by RCP57

Awesome Keith. Are you thinking of putting a softer cutting edge on it? I was looking around at stuff I had but wasn't sure if I should stick anything on there for you?

Thanks Reg, I may put a brass strip on the bottom of it. I'll wait till it shows up and I get the frame fit to it. Definitely going to add two feet / shoes to it.

Originally Posted by Lmackattack

That plow looks like it will dig in pretty good. Nice job fellas.

Thanks, the rears are locked on the DM so hopefully it will push OK.