Magom D11 hyd ram ratings?

[dozerbuilder]

Originally Posted by Rimrock

Some rough estimates...If assuming the kit consist of Magom's smallest standard rams with12 mm bore, and about 5 mm rod. (Best guess is that this size, at least, are used, but to know 100% you need ask them) Their new small pump gives up to 18-20 bar (~kg/cm2)
2 rams pushing; 2x 1.13 cm2 x 18 bar = 40 kgs
2 rams pulling; 2x 0.93 cm2 x 18 bar = 33.5 kgs


Rough estimates as mentioned, but 6 & 10 kgs should not be a worry

Hey thanks Rimrock. That's a great help. And that's their smallest bore size as you mentioned. They have 18 and 22mm bore too - need to check with them as you advise re sizes of the D11 kit but even the spec for the 12mm looks good + quite a margin of reserve capacity. I'd probably go with 4 x 22mm for the 4x barrel ripper and tilt and maybe the 18mm for the blade lift. I'll check with them as Lil Giants and yourself has suggested. Not sure if they communicate in English but no doubt will find out soon enough.

Thanks.

[Rimrock]

Originally Posted by dozerbuilder

Hey thanks Rimrock. That's a great help. And that's their smallest bore size as you mentioned. They have 18 and 22mm bore too - need to check with them as you advise re sizes of the D11 kit but even the spec for the 12mm looks good + quite a margin of reserve capacity. I'd probably go with 4 x 22mm for the 4x barrel ripper and tilt and maybe the 18mm for the blade lift. I'll check with them as Lil Giants and yourself has suggested. Not sure if they communicate in English but no doubt will find out soon enough.

Thanks.

Yeah they have the larger rams too. The dimensions are given on their webpage, so you can evaluate what sizes looks better visually on your dozer. They communicate in English.

[dozerbuilder]

Originally Posted by Rimrock

Yeah they have the larger rams too. The dimensions are given on their webpage, so you can evaluate what sizes looks better visually on your dozer. They communicate in English.

OK thanks for the heads up Rimrock, appreciate your input. My dozer in 1:1 is just a little larger than a D11 in 1:1 so the D11/Bruder kit size will look pretty good in 1/16th. I'll get the dims and do an update here for the benefit of anyone else looking into them.

Thanks.