|
|
|||||||
| Die-Cast Conversions Tech. The tricks of installing drive line and electrical components into die-cast models. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
07-27-2016, 01:22 PM
|
||||
|
||||
Re: 1/16 Oliver Dozer Conversion
Here is a short video of the first test run in the dirt. I am out of practice and i have to solve the loose track issue. Otherwise I think it is going to be usable.
http://youtu.be/T1b-CVwDljI Jim 
|
|
#2
07-27-2016, 02:16 PM
|
||||
|
||||
|
Re: 1/16 Oliver Dozer Conversion
It looks good in the dirt, seems to have plenty of push. I have no experience with those motor controllers but have a couple trucks with 645 servos and they are serious power hogs. I run a receiver battery in the trucks that have them so I don't notice it.
|
|
#3
07-28-2016, 04:45 PM
|
||||
|
||||
|
Re: 1/16 Oliver Dozer Conversion
It keeps getting better...
 Today I put bearings in the main drive assembly. I'm sure that will help runtime and power to the dirt. Added a dual rate and slowed it down to about half speed so I can control it pretty well when pushing. This way I can hold the stick full forward and steer, while running the blade with the other stick. I think I might have a bit of descent footage finally!  http://youtu.be/-n_qGyaEwGU Jim
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
