Skeeters contracting services

[skeeter]

Tonight, after dinner, I went to the garage to do a bit of work. Remember a while back I used the 3D printer to make a case for the Sabertooth 2X12 controller? Well today I got around to using that case. I had to modify it a bit to make it work for me. I wanted a protective case for the Sabertooth. This case was set up to be a direct bolt on unit. Since I DON'T wish to take the front loader apart further, I will be just resting this case inside the body of the machine. That said, I had to modify it a bit. rather then re-CAD this thing, I used my Dremel tool, & what Bo Wallen calls a "FAST TOOL". I needed to make openings for the wires to pass through the walls. Tomorrow, I'll go to the LHS & acquire the wire & connectors for the battery so I can get them installed. Here's a couple of pics of the Polish ingenuity I did to make the case work.

unnamed (62) by Anthony Kalnoski, on Flickr

unnamed (63) by Anthony Kalnoski, on Flickr

unnamed (64) by Anthony Kalnoski, on Flickr