Track pad info needed

[frizzen]

Check out SmallHauls' doepke Unit Cable Hoe thread, it uses #35 chain with k1 every other link. I believe he mentioned using carpet edge transition for pads.

http://www.rctruckandconstruction.co...ght=Cable+unit

Photobutt ate the pics, so you'll probably need the browser patch to see them

I think rvjimd also used that chain to run pads on version one of his Ny-lint michigan C-24 crawler base.

If that doesn't help, i think there were a couple Dozers running the chain too, and they had to make more gap between pads to let dirt fall out.

Post a pic of your setup.

[crusher]

Thanks for your reply Frizzen, the gap around the idler and drive sprockets is what i am trying to minimize, I was kind of hoping to hear from the guys who have printed off the pads with their 3d printers as i have just purchased a printer myself.
Thanks again
Terry