|
|
|
|
#1
07-10-2018, 02:38 PM
|
||||
|
||||
Re: LilGiantsConstrCo
Nearly finishing the 1st bench cut; I knew it was too high @17" with about a 2:1 slope, the hoe was 3" from the edge but it was always sinking a little as I reached out to fill the trls. Dozer time, new bench about 6" high will make loading much easier & SAFER! It'll be three more bench cuts to get down to the hardpan.
   Got a nice blast rain this morning @8am, 2/10's in about 10 minutes, a welcome cool down after four days of 35C... I forgot to put down my eave extension last night  ... got some dump trk hauling to do to fix the road    
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
 |
| Currently Active Users Viewing This Thread: 3 (0 members and 3 guests) | |
|
|
Hybrid Mode
