CAT 14M3 Motor Grader

[Hemi1966]

Originally Posted by Azonic

Awesome as always!
What made you start a new one?

There's couple of reasons, it was very fun project at the first time (or have I just forget all the not so fun parts) and I think I can make some areas better.
Also there's not too many grader projects going on over here.

[Azonic]

Originally Posted by Hemi1966

There's couple of reasons, it was very fun project at the first time (or have I just forget all the not so fun parts) and I think I can make some areas better.
Also there's not too many grader projects going on over here.

Ok! Hah, yeah I guess some parts are less fun then others!

Will be good to follow this one!

[JAMMER]

Great work and a lot of attention to detail as usual for you keep up the great work. Ed

[Hofabooz]

Hi

Its great to see another excellent build starting to take shape in your workshop.

looking forward to enjoying this build progressing.
many thanks for sharing with us all.

[Hemi1966]

I started to draw the front frame, I'm also trying to get it machined during weekend

[Hemi1966]

I got to the mill today, but it did not go quite as planned
The front frame is so long that i had to disable my limit switches on x-axis to get every millimeter in use. I of course at the other end my table hit the end and lost some steps. I did not noticed that right away but when I did, it was game over
The pocket was machined from two directions, and the left one wen't well, but on the right it lost the steps and the pockets did not quite meet

[Hemi1966]

Better success today