|
|
|||||||
| Highway Trucks and Trailers On road trucks and trailers single and twin axle trucks. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
10-19-2021, 04:36 PM
|
|||
|
|||
Re: Wedico Peterbilt Day Cab
First Step: Start rear-end disassembly
|
|
#2
10-19-2021, 04:42 PM
|
|||
|
|||
|
Re: Wedico Peterbilt Day Cab
Ordered and installed Wedico quarter fenders. I like the look of these over the full fenders. They need some modification, but they'll do for now. The stock spring suspension isn't very realistic... it will have to go!
|
|
#3
10-19-2021, 05:00 PM
|
|||
|
|||
|
Re: Wedico Peterbilt Day Cab
Well the stock spring suspension had to go! I ordered a walking spring suspension from Ric at PMD. When it arrived, I did a quick test-fit. YIKES. Not what I had in mind. Might be suitable for trucks in Europe, but did not look at all like a Peterbilt suspension. Another item that needed to go was the stock Wedico fifth wheel. A lot of stock Wedico/Tamiya trailers sit up too high for my liking, and do not look right to me. I want this truck to look as realistic as I can, while still functioning. So I ordered a ScaleArt fifth wheel. Waited a long time for it, but I am very happy with the reduced height and quality of the engineering of this one. More on the fifth wheel situation later!
|
|
#4
10-19-2021, 05:10 PM
|
|||
|
|||
|
Re: Wedico Peterbilt Day Cab
I tried and tried to convince myself to buy a suspension that was already designed, built, and ready to install. Nothing that I could find fit the bill. I decided on an airbag suspension, and the only one I could find out there was from Lesu. Can't be putting Chinese junk on a fine piece of German engineering! I was left with only one option... design and build it myself. This project is already turning into more than I bargained for, but I wouldn't have it any other way. Came up with this design based on the Peterbilt Low Leaf air ride suspension. The parts will have to be 3D printed, but with the high quality of metal (yes, I said metal!!) printing, I am not worried about putting poor-quality printed parts on a high quality model. Lots more to do!
|
|
#5
10-19-2021, 05:14 PM
|
|||
|
|||
|
Re: Wedico Peterbilt Day Cab
Well the first run of parts look amazing. I could not be happier with the quality of these printed parts. They are printed out of brass.
|
|
#6
10-19-2021, 05:16 PM
|
|||
|
|||
|
Re: Wedico Peterbilt Day Cab
The excitement is building. Cannot believe how well these parts turned out. I only ordered enough for one axle, just in case I messed up with my design.
|
|
#7
10-20-2021, 10:30 AM
|
||||
|
||||
|
Re: Wedico Peterbilt Day Cab
What does something like that cost for printing? I have some parts that if I can get time to draw, that need made.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
