|
|
|||||||
| Get it out of your system! HERE! You have a gripe,bone to pick, Tamiya vs Wedico or just have to let it out! THIS IS THE ONLY PLACE TO DO IT! |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
08-23-2010, 06:14 PM
|
||||
|
||||
Re: I hate Tamiya three speeds
Run the RC4WD R2. Freddy has done it in a couple builds. I think his daycab dumper didn't have room for the 3speed so he went with the R2.
|
|
#2
08-23-2010, 06:31 PM
|
||||
|
||||
|
Re: I hate Tamiya three speeds
You might have a bent shift fork,or rod. OR someone put bearings in the slider,WHICH is a no no! Bushings are made to slide on the shaft,NOT bearings.
Could always go w/a r-2,I have quite a few trucks w/r-2s in them,& love them. But have a lot more w/tamiya 3 spds & never had a problem with one. If you can't find the problem,p/m me, & I'll see what I can do to help you out. Good luck! FGD
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
