1/16 Bucyrus-Monighan Walking Dragline

[steamer]

Steve. Some of the finest machining I've seen in a long time. After all the time you've put in, it must give you lots of satisfaction seeing this come together.
Rob

[eef7260]

Super job Steve
You make big progress in a short amount of time.
Looking forward to your next picture post.
That big gearwheel on the clutch axle is that from an lathe ?? it looks extreme good in the crane like it's made for it.
And i have to agree with you on the sharpness of your end mills , but i noticed that i have never seen you using coolant fluid.
It increases the life time of your end mills a lot , and also the quality of the milled surfaces.

Eef