|
|
|||||||
| Australian Rigs & Roadtrains A place for aussies to show off their unique truck configurations. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
07-05-2011, 07:02 PM
|
||||
|
||||
Re: Scania W.A. Prime Mover 1/14.5
Love your 'LOADS' and the whole truck...
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
|
#2
08-14-2012, 05:26 AM
|
|||
|
|||
|
Re: Scania W.A. Prime Mover 1/14.5
After little Break, the construction goes on
 First a few pics from Events    I made a little bit on the Trailers. The rear bumber for the Dolly and the Lead was milled by a 8mm Alu-platte.    For the 45" Trailer, i made alu-plates on the exist brass-bumber. the holes are for the LED because of the small mounting deep of the original rearlights.   I went for the rail construction aluminum holder.    Next, I have 106 brass holder soft solder 
Last edited by Marcel74; 08-14-2012 at 10:09 AM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
