![]() |
|
General Discussion A place to post off topic discussions. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]()
Autocad had a version LT - it didn't have some if the fancier tools in it - but was good for what we do - worked with it for several years before they upgraded me lately at work.
Nice thing about autocad is that you can draft with the same techniques as you did on the board (paper and pencil) with the early versions. For some this means a lot. |
#2
|
|||
|
|||
![]()
I use punch ViaCAD 2d/3d and just set settings to inch/feet it measures it automatically
|
#3
|
|||
|
|||
![]()
I have used autocad lt for over 10 years on a computer with windows 98 and I have had no problems. I do not know if my cad lt program will run on windiws 7. One of these day I will call them and find out.
A new lt program is around $800. I am a little short on green stamps. Ken |
#4
|
||||
|
||||
![]() Quote:
http://en.allexperts.com/q/Windows-X...07-XP-Home.htm |
#5
|
||||
|
||||
![]()
I've been using a-cad LT 2002 , not bad til I transfered the dwg filles to visualmill then you start to see the open spaces in the drawing lines
![]() ![]() ![]() ![]()
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#6
|
||||
|
||||
![]()
When using AutoCad, (any version) set your units to the max precision (0.00000000) and the same with degrees. This eliminates these open corners. You can format the dimension style to the precision that you want displayed. Visual mill likes polylines that are closed to generate tool paths.
I have tried albre a few years ago, I hope the improved it since then. Last edited by Car5858; 07-31-2011 at 02:44 PM. Reason: typo |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|