Bruder Liebherr loader build

[doodlebug]

LOL! Did somebody call me?

Hey Pumptech, I'm the one with the Kyosho Hanomag loader manual, if you want a copy, pm me. Richard/vanisle & Travis have copies already for screw drive idea's.

Look's like a neat project. Cheer's, Neil.

[mikenredding]

I wonder if your screw drives could be made to be used for the turning rams.

[pumptech]

Originally Posted by mikenredding

I wonder if your screw drives could be made to be used for the turning rams.

Hey Mike ,I thought about that,was leaning more on using a high torque servo with linkages.Have played around with sliming the screwdrives down,leaving off the 1/2 SST ,using 3/8 and 1/4 ,with a smaller auger bit that fits in the 1/4.Then of course have to keep space in mind for the battery/electrical gear.

[pumptech]

Hey guys this post was mainly to check pic size,looks bigger on my end.
Little progress tonight,got a couple of the boom arms cut out so far,its a slow go.



Uploaded with ImageShack.us

[pumptech]

Little progress on the front portion,the boom looks a little rough right now,just tacked together,wanted to get the screwdrives made ,check things before i weld it out,got the bucket linkage made, have to tack down,hope to have the boom/bucket working soon..
http://
http://
http://
http://

[pumptech]

Well,I had a little setback on the boom, wasn't going to reach max hieght, the way I was going with it,with the servo incased in the front portion,had to come up with plan B ,reverse it ,put the servo in the boom,have the new boom tacked together,got the rams made,seems to work much better now ,has good lifting power with just the one ram,will be using two though,now onto getting the bucket going.
Have a few pics and vid.
http://

http://www.youtube.com/watch?v=ds87p...el_video_title

[pumptech]

Well,little update on the loader,been working on the swivel for the middle,rear section,now on to mounting the rear axle.Forgot to take a pic of the bottom of the model,but have metal tied in to the bottom,will get that pic on the next post.
http://


http://

[pumptech]

Originally Posted by doodlebug

LOL! Did somebody call me?

Hey Pumptech, I'm the one with the Kyosho Hanomag loader manual, if you want a copy, pm me. Richard/vanisle & Travis have copies already for screw drive idea's.

Look's like a neat project. Cheer's, Neil.

Hey Thanks Neil
Thanks for offering ,going to try the auger bit method first,same as my excavator,see how that goes,seem to get good power from them.If that doesn't work may have to give you a ring,thanks again.
Tommy