Mack M75SX

[ihbuilder]

tried to hual /unload my coal again but not worth the vid the dang thing is just too fast . I'm thinking 4 motors in the rear axles they're big enough . any how nuff cryin this is the idea behind the truck and loader
back my pickup to my bench and bridge to the upper section of the basement to unload my coal . some pics

looking in at the hopper for the furnace(55gal oil drum)


at my bench the unloading dock


I guess I'm just venting a little O by the way , any one wanna race this thing

[JensR]

Great setup for the haul road!
Although, as your resident health&safety expert, I urge you to install rails to prevent your beaut from plunging to death

About the speed: Can't you squeeze in a reduction gear box?
Your axles are sweet, wouldn't tear them apart.
Also, while my grader runs on wheel motors, a shaft drive is more realistic for most machines.

Good luck either way!