|
|
|||||||
| General Discussion A place to post off topic discussions. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
11-30-2011, 02:12 AM
|
||||
|
||||
Re: extended trucks
Here is a link to a how to that Tamiya Cowboy did on making drive shafts.
http://www.rctruckandconstruction.co...read.php?t=708 I also made mine like this. I am not home right now or I would give you part numbers for the parts needed, perhaps if you send TC a PM he will get ya the part numbers. Here is a pic of mine... The carrier bearing is made by Meir or Mier.. I got them on ebay but just looked and can not find any, don't know if anyone can help.  If you want to keep the truck some what realistic then you drive lines can not be more than 4.5 inches long. Here is my inter-axle. Again I have the part numbers at home for these but TC can get them for ya faster.  
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Mike "DREAMWEAVER" Johnson To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. RIP FreddyGearDrive 2-12-59/12-19-11 Rims and Tanks by ihbuilder / Grill and Visor by Brian in PA / Mirrors, Front and Rear Bumper, Back of Cab Lights, and Steering Arms by tc1cat / Fenders by Stylin n Profilin / Frame Rails by The Late Freddy Gear Drive 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
