![]() |
|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]()
This one will bolt up without any mods, although it will spin a little faster that the one i used before.
I can't remember the specs on this little guy, but it needed a custom adapter plate and i had to cut another motor coupler to accept the 2 mm shaft. ![]() |
#2
|
||||
|
||||
![]()
Well, the rc4wd 80T motor works nice. It only pulls .5 amps at 8.3 volts and 190 psi.
I ran for an hour and 15 minutes on one charge so, that is pretty good. That was running it almost non-stop though so, maybe 1 1/2 hours or more if resting between loading trucks. The motor sits at about 90 degrees and the esc sits at about 96 degrees.:-) Video of current draw with the pump running constantly: http://www.youtube.com/watch?v=BaeCC...1&feature=plcp Video with DX7s and mixing on the hydraulic functions: http://www.youtube.com/watch?list=UU...ture=endscreen
__________________
Scott "No load is too Small" |
#3
|
|||
|
|||
![]()
fantastic result.. and the bucket and boom move a lot quicker now.
__________________
Elliot. |
#4
|
||||
|
||||
![]() Quote:
http://www.youtube.com/watch?v=ZoK_a...vX_EuC2dhah0mM
__________________
Scott "No load is too Small" |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|