|
|
|||||||
| Truck Building Tech Covers mechanical and electrical components for truck modeling |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
09-08-2010, 06:31 AM
|
||||
|
||||
Re: f350/highlift tranny?
Thomas,I have a few F-350 tranys running a 10 tooth pinion.You have to grind the mounting holes bigger to drop the motor closer to the trany. Also have to cut top cover so motor can sit down in side of trany.
   On this one I used a brushless,But it can be done with brush motor. Just don't grind with trany together,remove end plate to do your butchin. Or just run stock pinion.   Hope this helps! FGD 
|
|
#2
09-08-2010, 06:15 PM
|
|||
|
|||
|
Re: f350/highlift tranny?
Thanx FGD, thats solved the problem. I've noticed the tranny is noisy, have you the same problem?
__________________
Dont mess with ma trucks To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by Juganought; 09-08-2010 at 06:18 PM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
