|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
09-10-2010, 02:56 PM
|
|||
|
|||
Re: Dozer wiring diagram
And if you had a spare proportional channel on the radio then you could run the pump with an esc and have a knob or slider on the remote which would act as the machines "throttle". Could be at full speed for coarse quick movements or half speed for fine movements like fine grading work or something. and still have the pump shut down when not needed.
__________________
Jeff 
|
|
#2
03-17-2012, 05:57 PM
|
||||
|
||||
|
Re: Dozer wiring diagram
I built a timer circut for my motorcycle stop lamp that when actvated, the stop lamp blinks 3 times and then goes steady. I used a radio shack generic board and a socket for the timer chip.
Source-http://www.allaboutcircuits.com Joe
__________________
"Experience is what you get right after you needed it."
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
