interesting to know on the dx5e tx

[dabears]

so by using the pico switch i could use say channel 5 on the flip switch, if i flip the switch it shuts down the truck into a standby mode? then just flip the switch again and it'll start? how long can the truck sit "off" like that? how different is it when you "start/stop" using the mfu? i didnt play with it much other then "stoping the motor" via remote for like 5 mins, then "starting it back up"...

[fhhhstix]

Originally Posted by dabears

so by using the pico switch i could use say channel 5 on the flip switch, if i flip the switch it shuts down the truck into a standby mode? then just flip the switch again and it'll start? how long can the truck sit "off" like that? how different is it when you "start/stop" using the mfu? i didnt play with it much other then "stoping the motor" via remote for like 5 mins, then "starting it back up"...

Yep use channel 5 and you can put it in standby mode and leave it there as long as you like since it is just sitting there looking for the missing signal.

Travis