|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
05-31-2012, 08:22 PM
|
||||
|
||||
Re: question about RC4WD hydro pump
Direct connection..
Although, if look at trucker47's build thread of his Cat loader, he has made a 3:1 belt reduction for that particular pump. I find that the direct connect pump/motor does not work that well for the excavator, but it might be ok for a dump trk. You should have been on the ball when Vanisle was selling all those hyd pumps & hyd accessories.. 
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
|
#2
05-31-2012, 09:24 PM
|
||||
|
||||
|
Re: question about RC4WD hydro pump
get a UMS landing gear pump for a dump I have 1 on my M75SX mack , it works great as it is . word of caution , if you go with the UMS pump , do not keep it running after you have dumped . these pumps work great for dumptruck apps with shourt run cycles . I dump over 50#+ with 2-.75 bore cylinders using 5/32 ID line .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
