|
|
|||||||
| Big Boys of the road 4x4/6x6/8x8/10x10 Trucks This forum is for those multiple axle trucks and other vehicles on and off road. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
11-13-2012, 02:05 PM
|
|||
|
|||
Re: tundra6x6 with Trailer!!
this was my idea of how it would look
   also bought two frames for extension!! 
Last edited by krankillen; 11-13-2012 at 02:15 PM. 
|
|
#2
11-13-2012, 02:17 PM
|
|||
|
|||
|
Re: tundra6x6 with Trailer!!
two become one! again!!
  
|
|
#3
11-13-2012, 02:21 PM
|
|||
|
|||
|
Re: tundra6x6 with Trailer!!
glued together rear truck bed!
 
|
|
#4
11-13-2012, 02:27 PM
|
|||
|
|||
|
Re: tundra6x6 with Trailer!!
now that I'm doing this. then I had no drawing! it was all in my head, the problems which arose were solved gradually.
cut the frame and welded them.   
|
|
#5
11-13-2012, 02:32 PM
|
|||
|
|||
|
Re: tundra6x6 with Trailer!!
I was going to raise the gearbox. it started good .... but when the body was in place, then the gearbox was too high. redo, do it right! Now it starts to get complicated.
 angle of the drive shaft became very sharp!!!!! Last edited by krankillen; 11-13-2012 at 02:35 PM.
|
|
#6
11-13-2012, 02:40 PM
|
|||
|
|||
|
Re: tundra6x6 with Trailer!!
had to rout a new aluminum plate with a different angle. so I could lay down on the gearbox on the side.
    
|
|
#7
11-13-2012, 02:41 PM
|
|||
|
|||
|
Re: tundra6x6 with Trailer!!
I was going to use the original steering.
 servo is moved from the side, in front of the gearbox instead. Last edited by krankillen; 11-13-2012 at 02:53 PM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
