tundra6x6 with Trailer!!

[krankillen]

two become one! again!!

[krankillen]

glued together rear truck bed!

[krankillen]

now that I'm doing this. then I had no drawing! it was all in my head, the problems which arose were solved gradually.

cut the frame and welded them.

[krankillen]

I was going to raise the gearbox. it started good .... but when the body was in place, then the gearbox was too high. redo, do it right! Now it starts to get complicated.



angle of the drive shaft became very sharp!!!!!

[krankillen]

had to rout a new aluminum plate with a different angle. so I could lay down on the gearbox on the side.

[krankillen]

I was going to use the original steering.







servo is moved from the side, in front of the gearbox instead.

[krankillen]

is not so much images on the rear wheels. it will be rear-wheel steering. intend to use the original steering here. but had to remove it. I put a servo instead.