|
|
|||||||
| Truck Building Tech Covers mechanical and electrical components for truck modeling |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
02-15-2013, 05:58 PM
|
||||
|
||||
Re: How to make 'hubcaps'...
NO not hot and cold faucet tops. Snap covers are little plastic covers that go over actual snaps like a coat snap.
__________________
Hi my name is Aaron.... And i'm a truckaholic! 
|
|
#2
02-16-2013, 12:16 PM
|
|||
|
|||
|
Re: How to make 'hubcaps'...
Ah...
I know Reg's are solid (just saw them) but think of a 'cap' that could be added like this... but they all don't have to be as fancy...  And dabears: Um, so they make 'em that big? You're looking at bigger than an inch in diameter... I don't think I've ever seen snap-covers that big. DIY button-making, yes (yanno, pin-on, etc) Gotta pic or source? There... finally got image to show up... and sweet work Reg, VERY sweet. Last edited by WhiteWolf McBride; 02-16-2013 at 12:21 PM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
