D9R and 463 pull scraper

[ihbuilder]

Joe , you told me on GT and I didn't save it , where did you get the T bar ? I google it and get a whole bunch of BS .

Thanks Steve

[9W Monighan]

Steve, You need Tee bar? I have tons of it. What size?

[JAMMER]

Joe sorry to hear the Cat through a chain what caused that? Have you got all the problems with the pan worked out? That video you took looked good. Ed

[ihbuilder]

Originally Posted by 9W Monighan

Steve, You need Tee bar? I have tons of it. What size?

Steve , to do what joe did ,I would need the same size 1.25 x 1.25 x 1/8 . prob is I have this want to make them look exactly like the real pads . I'm thinking of putting a horizontal mill cutter on my lathe w a vice on the cross feed and mill them . unless your up to it like you did for your I beams How big of T do you have ? PM or call . I could do what I want ,with 1.5 or 1.75 would be easier . got this project just about off the drawing board just some lil details . Sorry Joe I'm hijacking

IHSteve

[dirtpusher9]

Originally Posted by ihbuilder

Joe , you told me on GT and I didn't save it , where did you get the T bar ? I google it and get a whole bunch of BS .

Thanks Steve

Steve I told you wrong it is 3/16'' not an 1/8''. Here is a link. http://www.allmetalsinc.com/steeltee.html

Originally Posted by JAMMER

Joe sorry to hear the Cat through a chain what caused that? Have you got all the problems with the pan worked out? That video you took looked good. Ed

Too lose of tention on the chain. The pan is fixed just waiting on time to video and a camra operator.

[ihbuilder]

Thank you Joe 9WSteve has some and he's some what in route to St.louis

IHSteve

[dirtpusher9]

Here's a new video of the scraper short hauling. The material was a little sticky and had some operator error but we had fun.

http://www.youtube.com/watch?v=TIs3vi7iC5c

[ihbuilder]

joe thats looks like your getting some good wear on it

IHSteve