![]() |
|
Highway Trucks and Trailers On road trucks and trailers single and twin axle trucks. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]()
Welcome to the forum, Darwin. There are a lot of great people here to make friends with and a wealth of knowledge on the site.
![]() I like what you did with the whole unit. That is a Master Build. ![]() If you have any tips about how to make the curb window, I'd appreciate it. ![]() I've wanted to install one in to a couple of my trucks, but I'm at a loss as to how to make it come out that nice. ![]() The trailer suspension is also very nice. If you have more photo's, please post them. ![]() - RCT
__________________
WCMT Director - To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. "Keep the Shiny-side Up, the Dirty-side Down & Keep 'er to the Line." |
#2
|
|||
|
|||
![]() Quote:
As far as the curb window goes, I think for the window itself I used a piece from an r/c aircraft window, but any thin piece of clear or tinted window from a toy truck or even the old Lego house windows, they were clear or tinted I think, just pop out the lense and that would work for the glass. The rubber molding is a thin rubber o-ring , the grommet kind that has the groove in it, that I cut to the right length and glued in around window opening in the door. I just used a tiny amount of glue in the groove so none of it squished out on to the outside of the door. Once the glue dried I think I took a razor blade and shaved the part of the o-ring off that protruded to the inside of the door giving me a mostly flat area on the inside. Then I cut a piece of plastic glass a little larger than the opening so no glue would squish into view and glued it flat against door and o-ring. That was 6 years ago but I believe that is how I did it. I had spent many many hours already lengthening hood, cutting the front fenders off and reshaping them, filling in the hood etc. and THEN I think "oh lets put in a curb window". Luckily it went fine, but I would definitely cut the hole first before spending lots of time elsewhere in case it goes wrong and you ruin or crack the cab when cutting hole. I was very nervous cutting a hole in the door after I had spent so much time on the body work as I worried something bad would happen and I would crack the whole cab or ruin something. ![]() Darwin |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|